After getting the interior taped and filleted it was time to flip the boat again to finish up the hull.

After some more fairing I fully glassed the bottom and lower panel.

 Then put the skeg together

At the same time I steam bent the bow trim

 Laminating them in place

 Also putting up the rudder blocks by putting them on a jig to make sure of distance and angle

Once in place everything was filleted. I also have decided to glass cloth the skeg for further protection.

Doing my filleting was made easier by being able to angle the boat \.

Pre-coating seat panels, but will be fairing out the hull before flipping again.