Sanding, fairing sanding....repeat

Getting the hull sealed up, little bit more and tape the bottom. I plan on fiberglassing the whole bottom but may have to wait on that as I think it would be safer to do with two. So probably after taping I will flip the boat and work on the inside.

Also getting started on the foils for rudder and daggerboard. Using solid wood for these;

All planked up and nowhere to go

Now comes the hours of filling, fairing and sanding.

Planking

Making some progress, have the lower and middle planks on both sides.

I did have to stop and make an adjustment on one of the middle planks. The original finger joints were loose and shifted while gluing putting the plank out of shape. Even if I could purchase another sheet to reproduce it, it would mean a 300 mile round trip so instead I patched in a piece of 6mm that I had. Was able to remake the correct shape.

Steamed

Finding ways of handling the 3+ meter stringers took a little work, but by the third one I had it down. I did have to switch ends of the poly tubing during the steaming since the most pronounced curves were at the bow and stern.

I am now looking forward to finding other pieces of wood to bend.

I have a sufficient planing and smoothing to do for awhile, before planking.

Once the weather warms and drys I also have a lot of precoating to do.

Steaming away

After a vacation hiatus and waiting for the Rockler steamer to arrive I was able to get back to work. Perfect timing as it looks like I will have little else to do while "sheltering at home" for perhaps a month or more...gulp.

First off was gluing down the bottom which went without a hitch.

Then came the stringer which I had originally tried to do without steaming which did not work.

So after picking up a steamer and poly tubing as advised be Bob Wessel I put my first stringer up this afternoon.

This is a little fitting I fabricated to make the connection with the tubing

The stringer is in place with the poly still on, tomorrow I will pull it off and then make sure it is dry before gluing. The three more I have to do should go a little quicker than the first.

Setback

I guess the curve was too much for the VG Fir stringers.
Though I had them worked around to the very stern.

Where I was slowly trying to pull them in.

But.......Apparently sometime in the last two days while I was away they decided to split on both sides.

I have yet try the gunnel stringers, but if it looks like they will do the same I will have to rethink, as this wood is much too expensive to waste. The problem is it is the only thing available to me here in the proper length and to my mind appropriate material.

Some progress;

Frames are going up, dagger board case and mast step in place. A little bit of adjusting and planing here and there should allow bottom panel to be placed soon.

Starting to look like a boat.